Specifications

48
Symptom Possible Causes Remedies Prevention
Check Valve positioning (Section Error!
Reference source not found.)
Prints are blurry or fuzzy Image resolution is too low
printed on is set too Media to be
low below the Print Head
Print Head may be out of
alignment
Re-sample the image in the graphics
software to a higher resolution
Raise the Printer Bed so that the Media
(T-shirt, etc.) sits just below (1-2mm)
the side walls of the Printer Bed.
Print Head Alignment (see Undertake a
Section 8.16)
ality graphics
int
Use good qu
– image at the final pr
size should be between
200 and 300dpi
that
Always use the Height
Checking Jig to check
the T-shirt is at the
correct height in the
Printer Bed (see Section
7.1)
Prints have incorrect
colours (eg. Greens are
yellow or blue, Purples
are blue or pink etc.)
Not all channels / nozzles are
printing properly
See above for good Nozzle Check ozzle See above for good N
Check