Specifications

31
Light coloured garments whe
not require any pre-treatme
re you are not planning to p
nt process.
Place the garment on the GARMENT PLATEN. Put
around garment and
surface. Any excess
l
between the t nt
Platen. If you
very large or a
polar fleece, y
the Garment P
push any exce
the Garment P
4. Put the Garment Holder on the PRINTING BED.
The Garment Holder must lay flat on the Printing bed,
wrinkles and is flattened out to prevent problems with
5. Position the garment in the PRINTING BED.
Line the front edge of the Garment
collar of the t-shirt / top of the garment shou
printed garment must sit just below the travel
of the Printing Bed / Garment Holder so that the Gap
ed image will appear out of focus if the garment is set too
t level on the P
rinkles in the garment or seams sitting high which may
lease Note: The Printing Head must not hit the garment or the Garment Holding Ring. If
u will have to do a head cleaning before the next print.
re-treated fabric, the pre treat may seal the ink in the
ediately perform several head cleans – and potentially
th a new one. If it touches the Garment Holder you will
Head hits the Garment Holding Ring or even
me force, you may have to replace the Print Head with a new
6. Move the Moving Head Unit into the Loaded Position.
rint any white ink generally do
3. Put the garment into the GARMENT HOLDER / PLATEN.
the metal HOLDING RING
flatten out the printing
garment shou
d be pushed into the space
op and bottom of the Garme
are printing on a garment that is
made of a thick material like
ou can simply lay the garment on
laten without the holding ring and
ss material into the space between
laten top and base.
so ensure the garment has no
the printing process.
Holder with the front edge of the Printing Bed. The
ld be at the front of the Printing Bed. The
path of the Print Head – use the Up and
Down buttons to adjust the height
LED is not on (just!). The print
low or the Garment Holder is no
start printing that there are no w
trigger the Gap sensor.
rinting Bed. Always make sure before you
P
it lightly brushes the garment yo
If it even lightly brushes against p
head, and you will need to imm
have to replace the Print Head wi
have to do a head alignment. If the Print
the garment itself with so
one.
Press the LOAD button to make the Moving Head Unit move into the Loaded position
over the Printing Bed. The Gap sensor will operate during the LOAD process to detect
any part of the garment that may protrude too high into the Gap. If the sensor beam is
cut by protruding garment or other foreign object, the LOAD process will halt and the
Gap LED on the front Control Panel will ignite. Lower the height of the Printing Bed and
/ or smooth wrinkles in the garment and / or remove foreign objects before pressing the
LOAD button to continue the LOAD process. If necessary, press the EJECT button so that
you have full access to the loaded garment to ensure that nothing is sitting too high
(refer point 5. above).