Specifications

26
6.2 Printing a Nozzle Check Pattern
To check that the Print Head is fully charged with Ink and ready to print, you will need to
print a Nozzle Check Pa
You should also print th
production if lines or ga
quickly whether there a lly
charged with ink – whic
the Head Clean / Nozzl
The Nozzle Check Patte ntenance tab of the Printing
Preferences dialog for your Windows Epson R2400 printer driver.
Ready
ED green). Lay some clear transparency or clear packing tape on top of the GARMENT
butting up against the front right corner of the Printing Bed. Ensure that the gap
ent Holder and the Print Head is at minimum: use the Up and
e loaded position.
o to the bottom right corner of the Task Bar on your computer and Right-Click the Printer
Then select Head Cleaning. If there is no printer icon on the Task Bar, go to the Start
utton on the bottom left of your computer, choose Settings, then Printers & Faxes. Right
lick over the Epson R2400, select Printing Preferences and then click on the Maintenance
tab.
ttern.
is Nozzle Check Pattern each day before production and often during
ps start to appear in your printed output. This will identify very
re blocked nozzles in your print head or the Print Head is not fu
h in most cases will be cleared very quickly by following through with
e Check cycle as described below.
rn can be printed from the Mai
Perform a Nozzle Check when the printer is in a Ready state (Power button LED solid,
L
HOLDER
between the top of the Garm
Down buttons to adjust the height of the Printing Bed (with Garment Holder) so that the Gap
light is just off. Refer to the previous Control Panel section for further information. Make
sure that the Moving Head Unit is in th
G
Icon.
b
c
Click on the Nozzle
Check icon.