Specifications

The Down button, when pressed, will lower the level of the P

anything that may be positioned on the Printing Bed, such as

rinting Bed and

a Garment Platen).

Press once for a small movement, press and hold for larger movements.

The Gap On/Off button, when pressed, will t

Moving Head Unit. The Gap Sensor uses lasers e

in a garment) that are in the path of the Prin

during the LOAD, EJECT and printing process

garment or garment platen (or other foreign object) that

gap between the print media and the Print Head. This is t

not strike anything during the printing process.

Please Note: The Printing Head must not hit the garment arment Holding Ring (or

any other foreign object). If it lightly brushes the garment you will have to do a head

cleaning before the next print. If it even lightly brushes against pre-treated fabric, the pre

treat may seal the ink in the head, and you will need to immediately perform several head

cleans – and potentially have to replace the Print Head with a new one. If it touches the

Garment Holder you will have to do a head alignment. If the Print Head hits the Garment

Holding Ring or even the garment itself with some force, you may have to replace the Print

Head with a new one.

efore strongly recommended that you do not turn off the Gap Sensor at any time.

Indicators:

The Power LED, when lit, indicates that the A/C power supply is connected and

switched on at the rear of the printer. Note: the Power LED will extinguish

(and in fact, the A/C power supply to the printer will be cut) if the Emergency

Stop button is engaged.

that the laser sensor beam is no longer interrupted. If necessary, press the

EJECT button so that you have full access to the loaded garment to be able to

kles / remove objects, etc.

urn on or off the Gap Sensor in the

to sense objects (such as a wrinkl

t Head. The sensor will operate

es to detect any part of the

may intrude upon the pre-defined

o ensure that the Print Head will

or the G

It is ther

LED Status

The Ready LED, when lit, indicates that the Moving Head Unit is in the loaded

position and is ready to receive print data.

The Gap On/Off LED, when lit, indicates that the Gap Sensor in the Moving

Head Unit is operational.

The Gap LED, when lit (orange), indicates that the Gap laser sensor beam has

been cut by protruding garment or other foreign object, and the LOAD, EJECT

or printing process will have been halted. Lower the height of the Printing Bed

and / or smooth wrinkles in the garment and / or remove foreign objects so

smooth wrin