Specifications

14
Protect any carpet or floor covering with mats or old carpet as there is a risk of
spilling wet ink when you refill the bulk ink bottles.
Place the DTG HM1 Kiosk™ close to the heat source that you are using to cure
the ink so that you have a smooth workflow, but ensure that heat does not
radiate directly on to the DTG HM1 Kiosk™. If you have more than one DTG
HM1 Kiosk™, place them around the heat source or close to it.
When you have placed the DTG HM1 Kiosk™ unit on the work table, remove the
any packaging covering the unit. Check the unit carefully for shipping damage.
If you find any obvious damage please contact the freight carrier immediately
to arrange a freight inspection.
Remove the two special holding brackets attached each side/ back of the
printer by removing the two screws holding each bracket, then slide the
brackets out. Put these brackets and screws aside as you will need them should
you wish to transport the printer in the future.
Printer side v
BAC
K
iew with bracket
Printer rear view
with bracket