Specifications

5.1 Unpacking and Positioning the DTG HM1 Kiosk™

Please read the following directions through before unpacking your DTG HM1 Kiosk™:

Prepare a work area with a solid work table that will not vibrate when using

the DTG HM1 Kiosk™. Allow extra room for your computer, replacement in

and space to work. See diagram below for approximate dimensions of the un

and minimum workspace area required.

Carefully remove the printer from the box, taking hold of it by the sides of the

black base unit.

Place the printer on the work table which should be leveled first. The unit

must be kept away from direct sunlight, dusty areas, excessively high humidity,

strong magnetic forces and direct airflow which can dry out and clog the

printing heads. It is recommended that the unit be kept in an air-conditioned

temperatures no less than 5° Celcius (41°F) and no more

6°F) with humidity levels between 40 and 70%.

environment, with

than 30° Celcius (8

Provide a separate room for the spraying of pre-treatment to the garments

prior to printing. If a separate room is not possible, you must allow a minimum

of 5m between the spray station and the DTG HM1 Kiosk, and ensure that

forced extraction of the pre-treat vapour is carried out. Failure to adhere to

these recommendations will resul

t in erratic print quality and the need for

numerous head cleans both before & during printing. This erratic behaviour is

likely to worsen until the print head fails and has to be replaced.