Specifications

43
10. Printing Other Textile Items with the DTG Kiosk™
You can print on anything that can be held in place with the DTG Kiosk™ and you don’t need a
clamp to hold them in place. Bags, Tea Towels, Mouse Pads, etc can simply lay on the Garment
Holder. The most important thing is to remember to check the head clearance. Items that are
smaller can be placed on smaller Garment Holders or you can make your own fixtures to hold
items. Spray adhesive or sticky table tack can be placed on these special holders to keep the
items from moving. Just remember to adjust the head clearance with the Height Adjusting Knob
as the printing surface should sit just below the printing head.
Any products which have excess fabric or seams should be set lower than the printing surface.
To accommodate this excess fabric you may have to design a special cutout from foamcore or
other thin material, the same size as the printing area. This cutout can be spray glued to your
normal Garment Holder and then you can use spreadable Table Tac (available from Impression
Technology) to hold the item in place. TableTac stays sticky for dozens and even hundreds of
prints and can be “renewed” by simply wiping it down with a wet rag. Impression technology
also has a special double-sided tape to hold items in place.