User Manual

DTC COMMUNICATIONS, INC.

PROGRAMMING

Programming

1 Make sure the video transmitter ON/OFF. The red dot is OFF.

2 Make sure the transmitter has an antenna installed into the antenna

connector prior to programming.

3 Install the programming cable into the Multi I/O connector on the transmit-

ter

4 Connect the programming cable into a power source.

5 Plug the serial cable of the programming cable into the COM1 or COM2

port of your computer and turn the

transmitter switch to ON. The green dot is ON.

6 Select Start, programs, DTC communications on your computer.

7 The system allows you to select device COM1 or COM2, depending on

which serial port you are connected to.

8 Follow the instructions on the DTC Universal Programming screens to

begin the download process.

9 The frequency settings that are currently in your transmitter are down-

loaded to your computer.

10 Click on the “Tx Channel” tab in the programmer screen.

11 Select a channel and click on the Edit Channel button to change settings.

12 Enter your new frequency and settings.

13 To change any of the MIC-2 or MIC-1 settings, click on the settings

provided, then click OK.

14 Click on the Upload button to upload your new settings to the transmitter.

Your new settings have been installed.