User Manual

DTC COMMUNICATIONS, INC.

QUICK START GUIDE

1 Make sure that the ON/OFF switch is set to OFF. (Red dot is OFF).

2 Install 4 “AA” batteries in the internal battery compartment of the module.

(Lithium batteries are recommended)

3 Using a screwdriver, turn the channel selector to the correct transmission

channel number.

4 Connect an antenna to the ANTENNA connector on the module.

5 Connect the microphone or microphones to the MIC-1 and MIC-2 connectors

on the module.

6 Connect a video source to the Video/Multi I/O connector.

7 Slide the power switch to the ON position (Green dot is ON) to apply power to

the transmitter.

Note: While installing the batteries, observe proper polarity as printed in the

battery compartment. Reverse polarity protection is a built-in design feature

of the transmitter. If a battery is installed backwards, this feature prevents the

transmitter from powering up, without damaging the transmitter or battery.

Warning: Do not apply power to the transmitter until an antenna has been

connected in step 4.

Warning: Refer to Appendix A of this manual for information on the proper

use of antennas.

7 1