User Manual

10
MICROPHONE CONNECTORS
Two connectors accommodate two microphone inputs.
Each connector has two contacts and provides power to the
microphone as well as connecting the audio signal into the
transmitter. The audio sub-carriers are activated by the
presence of the microphone. If a microphone is removed,
that sub-carrier is removed from the transmit signal.
Turning off the unused sub-carrier saves power and
improves picture quality.
Microphone Connectors
CONNECTORS
Lemo Male Part # (FFS.01.250.DLAE31
)
DTC Male Part # (8570003)
Hirose Part # HR10A-7P-6P (02)
DTC Part # 954020
MATING CONNECTORS
Antenna Connector
WARNING: Refer to Appendix A of
this manual for information on the
proper use of antennas.
ANTENNAS
A standard SMA connector is used as the antenna connector
on both the VMS-5000. Refer to a list of DTC antennas
available on page 16.
TIP: You may use the VMS series transmitters with
other manufacturers antennas. Verify that they are
suited for the band you are operating in.
Standard Male SMA Connector