User Manual

6
SPECIFICATIONS
RF Specifications
General Specifications
ITEM SPECIFICATION
Power Input Voltage External 11-16 Vdc
Power Consumption 7.2 Watts (not including camera)
Reverse Polarity
Protection
YE S
Dimensions 3.9 x 2.7 x 0.512”
Camera Power
Same as supply voltage going
into the transmitter. Current
limited to 200 mA.
Controls
10 channel select rotary switch
Panel mounted, recessed slide
power selection switch
Connectors
2 pin Lemo: Mic 1
2 pin Lemo: Mic 2
SMA: Antenna
6 pin Multi I/O: Video in, Data in,
DC input 11-16 Vdc, camera
power, Remote ON/OFF,
Multiplexed Data out, Ground
Programmability
Video: 2450-2500 MHz
(VMS-2000)
250 KHz resolution steps
Audio: User programmable from
6.0-7.5 MHz, in 10 kHz steps
Chassis notes
Machined, solid aluminum with
rounded edges
ITEM SPECIFICATION
Operating Frequency
2450-2500 MHz, 250 KHz
resolution steps
Power output
2000 mW min. @ nominal
supply voltage, 25 Deg. C.
-3db @ 7VDC ext. -2 dB
over temp.
2.5W maximum
Output Impedance 50 Ohms
Spurs and Harmonics output -50 dBc
Load Pull Stability 8:1 VSWR
Frequency Stability +/- 0.003%, -30 to +50°C
Modulation Sensitivity 8 MHz/V nom.
Modulation Sensitivity Variation +/- 5% across the band
Peak Carrier Deviation 4 MHz nom.
Number of channels 10 max. (user programmable)
Sub-carrier sideband level -28 dBc, +/- 2 dB
Environmental Temperature Range -30-+70°C
Humidity 90% (non-condensing)