User Manual

3
TABLE OF CONTENTS
Quick Start ........................................................................... 4
Overview .............................................................................. 5
Specification......................................................................... 6
Current Drain and Battery Drain .......................................... 8
Heatsink Information ............................................................ 9
Connectors......................................................................... 10
Connections ........................................................................11
Equipment Configurations ................................................. 12
Optional Accessories ........................................................ 14
Appendix A ......................................................................... 23
Programming Introduction.................................................. 24
Installing Programming Software ....................................... 25
Programming Procedure .................................................... 26
Manual Conventions
NOTE Describes special issues you should be aware of
while using a particular function.
WARNING Calls out situations in which equipment could
be damaged or a process could be incorrectly imple-
mented, but in which operator safety is not a factor.
TIP Describes application hints.
RF EXPOSURE STATEMENT
This product is NOT to be used in a bodyworn application.
Refer to Appendix A in this manual for instruction in the
proper use of antennas with this device. When in use a
separation distance of at least 50 cm. must be maintained
between the antenna and the body of the user or nearby
persons.
Note: This device is for occupational use only. Occupa-
tional users are those persons who are exposed as a
consequence of their employment, provided these
persons are fully aware of and exercise control over
their exposure.
FCC ID# H25VMS2000
What should you expect to receive with your 2W Transmitter?
1 VMS Video Transmitter
1 Dipole antenna with right angle SMA connector
1 DTC programming software package
1 DTC programming cable
1 One Video and Power In “Y” cable