User Manual

PROGRAMMING

1 Make sure that the power to the video transmitter is off.

2 Make sure the transmitter has an antenna installed into the antenna connec-

tor prior to programming.

3 Install the programming cable into the Multi I/O connector on the transmitter.

4 Plug the serial cable of the programming cable into

the COM1 or COM2 port of your computer.

5 Connect the programming cable into a power

source.

6 Select Start, programs, DTC communications on

your computer.

7 The system allows you to select device COM1 or

COM2, depending on which serial port you are

connected to.

8 Follow the instructions on the DTC Universal

Programming screens to begin the download process.

AC POWER

COM1 or COM2

Serial port of computer