User Manual

10
MICROPHONE CONNECTORS
Two connectors accommodate two microphone inputs. Each
connector has two contacts and provides power to the
microphone as well as connecting the audio signal into the
transmitter. The audio sub-carriers are activated by the
presence of the microphone. If a microphone is removed,
that sub-carrier is removed from the transmit signal. Turning
off the unused sub-carrier saves power and improves picture
quality.
Microphone Connectors
CONNECTORS
Lemo Male Part # (FFS.01.250.DLAE31
)
DTC Male Part # (8570003)
Hirose Part # HR10A-7P-6P (02)
DTC Part # 954020
MATING CONNECTORS
Antenna Connector
WARNING: Refer to Appendix A of
this manual for information on the
proper use of antennas.
Standard Male SMA Connector
ANTENNAS
A standard SMA connector is used as the antenna connector
on the VMS-2000. Refer to a list of DTC antennas available
on page 17.
TIP: You may use the VMS series transmitters with other
manufacturers antennas. Verify that they are suited for
the band you are operating in.