User's Manual
3
NOTE: Describes special issues you should be aware of
while using a particular function.
WARNING: Calls out situations in which
equipment could be damaged or a process could be
incorrectly implemented, but in which operator safety is
not a factor.
TIP: Describes application hints.
RF EXPOSURE STATEMENT
Only the S-Band unit (DTC Part# VMD-TX-S) unit has been approved ๎for
body-worn applications (FCC ID H25VMDTX100S), and only when used in
conjunction with DTCโs Palladium Digital VidiVest (DTC Part# Pd-VidiVest-
XX) or Digital Video Jacket (Pd-VIDI-DJ).
For any configuration other than described above, a separation distance
of at least 20 cm must be maintained between the antenna and the body
of the user or nearby persons.
When units are used consistent with the two previous notices, they
comply with FCC radiation exposure limits set forth for an uncontrolled
environment , per FCC Rules & Regulations, sections 1.1307, 2.1091 ๎&
2.1093, as required by section 90.1217.
NOTE: Do NOT allow the device to directly contact the
skin due to warm operating temperatures.
manual conventions
Quick Start ....................................................................................................................4-5
Accessories ........................................................................................................................ 5
Introduction ........................................................................................................................ 6
Operation ....................................................................................................................7-8
Using your VMD Transmitter .............................................................................. 7
Selecting your Transmitter Configuration .................................................... 7
Front Controls ............................................................................................................ 7
Top and Bottom Connectors ............................................................................... 8
Programming .................................................................................................................9-17
System PC Controller Application Software ................................................ 9
Transmitter Control Application .............................................................. 11-17
Specifications .............................................................................................................. 18-19
Connector Pin-Out ...............................................................................................................20
Notes ......................................................................................................................21
Warranty ......................................................................................................................22
Contact Us ......................................................................................................................23
๎
TABLE OF CONTENTS