User Manual

DTC COMMUNICATIONS, INC.
7
QUICK START
Accessories
1 T-2500-M Transmitter
1 36” Tibbets External Mic
6 CR2 Batteries
1 CR2 Battery Pack
4 AA Lithium Batteries
1 AA Battery Pack
4 AAA Lithium Batteries (option)
1 AAA Battery Pack (option)
1 Battery Cable
1 Data sheet
1 Noodle Antenna
1 DC Power Cable
1 Operator’s Manual
1 Screwdriver
1 Prog./Watermark Software
1 USB Cable
LED Status
Modes OFF: Congurable LEDs are always OFF
Covert: Congurable LEDs show for 5 seconds.
Normal: Congurable LEDs are always ON.
Power ON
(Always happens)
Bi-color LED green LED lights as soon as possible. Green LED
stays lit for a few seconds until another indication happens as
shown below. This provides button press feedback.
Power/Channel select button
(Always happens)
Once the button press is detected the red LED will come on solid.
The LED will then blink until power down is complete. While the
red LED is illuminated, the user must not disconnect the battery.
If the button is released after the LED starts blinking the unit will
continue to power down (and blink the LED) until power down is
complete.
USB
(Always happens)
Bi-color LED, blinking green LED when USB is connected.
TX and record active
(Congurable)
Bi-color LED, blinking alternating green and orange (dened as
red and green lit).
Record only active
(Congurable)
Bi-color LED, both LEDs lit at the same time (orange).
TX only
(Congurable)
Bi-color LED, green LED lit.
The Status LED is used to give status indication. The LED function is
controlled by a global setting to be one of three modes:
OFF: Unit gives power ON and OFF status but no other indications,
COVERT: Unit indicates state change for approximately 5 seconds every
time the state changes,
ON: Unit constantly indicates the status using the LED.