User's Manual

16
Programming
Your new settings have been installed.
NOTE: Width refers to channel spacing. 12.5 kHz =
Narrowband. 25 kHz = Wideband
1 Connect the antenna to the T-2350 transmitter.
2 Install the programming cable into the connector on
the T-2350.
3 Plug the serial cable of the programming cable into
the COM1 or COM2 port of your computer.
4 From the Start Menu, Select Programs>DTC
Communications>COM1 or COM2 on your computer.
5 The cycle power screen displays.
6 Slide the power switch to the ON position and click OK.
A message screen displays T-2350 downloading.
7 Click on the TX Channels Tab.
6
9 Enter your new settings and click OK. (See Programming
Options pages 18-21) You can change the frequencies,
mode, key ID, misc source, AGC, and bandwidth
The programming software returns
to the TX channels screen with
your new settings displayed, and
an asterisk (*) beside the channel
that has changed.
10 Click on the upload button.
A message screen displays the new settings being
uploaded to device.
A message screen
displays that your
settings have been
successfully uploaded.
8 Click on the channel you need to change and click on
the Edit Channel button
1
2
3