User Manual
DTC COMMUNICATIONS, INC.
5
5
6
QUICK START
5 When power is applied, the green RF LED turns ON. The channel
number LED also turns ON, representing the most recent channel
setting from the last time the transmitter was used. Push the RF button
to transmit.
6 If you need to change the operating channel, press the CONFIG button
to cycle through the 8 available channels indicated by the channel
number LEDs. Refer to the Programming section on page 10 for more
information on channel settings. When you change the channel
configuration, the RF transmission is automatically switched OFF to
prevent accidental interference. When you have selected the channel
you need, push the RF button for one second to start transmitting
again. The RF LED will turn ON.
NOTE: A red ALARM LED indicates that no video is connected.
Your Transmitter is now operational. Confirm its signal with your
Palladium Receiver.
Palladium TX-1000 Transmitter Controls
NOTE: Eight Channel LEDs are located on the control panel.
If all 8 green LEDs are flashing, this indicates that your battery
source is low.