User Manual

DTC COMMUNICATIONS, INC.

QUICK START

4 Slide the control panel door to the right.

5 When power is applied, the green RF LED turns ON. The channel

number LED also turns ON, representing the most recent channel

setting from the last time the transmitter was used. Push the RF button

to transmit.

6 If you need to change the operating channel, press the CONFIG button

to cycle through the 8 available channels indicated by the channel

number LEDs. Refer to the Programming section on page 10 for more

information on channel settings. When you change the channel

configuration, the RF transmission is automatically switched OFF to

prevent accidental interference. When you have selected the channel

you need, push the RF button for one second to start transmitting

again. The RF LED will turn ON.

NOTE: A red ALARM LED indicates that no video is connected.

Your Transmitter is now operational. Confirm its signal with your

Palladium Receiver.

NOTE: The RF switch should remain ON during normal use. The RF

automatically shuts off during programming to prevent accidental

transmissions on unintended frequencies.

Palladium Transmitter,

Front View

Optional Data and

Chaining Connector