User's Manual

5
INTRODUCTION
Using your Palladium II Transmitter
Follow the instructions given in the Quick Start section on pages 6-7. When power is first ap-
plied to the Palladium, the unit reverts to the indicated channel and RF ON state. The Alarm LED
may be ON, which indicates that there is no active video input.
Changing your Transmitter Configuration
The Palladium Transmitter can store up to 8 different configurations, which can be selected
with the Channel Control. The frequency channels are preprogrammed please contact your
local Sales Manager for more information
Top Controls/Connectors
• Multi-I/O Connector
• Data Chaining & Control Connector.
• Audio 2 (left) and Audio 1 (right/mono) LEMO Conn. These connectors provide the audio
input connections to the transmitter. Either one or two audio inputs can be used with the Pal-
ladium II Transmitter.
• Frequency Channel Controller
- Fmin = 1 (2451.25 MHz)
- Fmid = 2 (2466.00 MHz)
- Fmax = 3-8 (2482.50 MHz)
Bottom Controls/Connector
• SMA Antenna connection