User's Manual
3
NOTE: Describes special issues you should be aware of
while using a particular function.
WARNING: Calls out situations in which equipment
could be damaged or a process could be incorrectly
implemented, but in which operator safety is not a
factor.
TIP: Describes application hints.
RF EXPOSURE STATEMENT
This Unit is NOT FCC-approved for body-worn
applications. A separation distance of at least 20 cm MUST
be maintained between the antenna and the body of the user or
nearby persons.
When the unit is used consistent with the two previous notices,
it complies with FCC radiation exposure limits set forth for an
uncontrolled environment, per FCC Rules & Regulations, sections
1.1307, 2.1091 & 2.1093, as required by section 90.1217.
NOTE: This device is for occupational use only.
Occupational users are those persons who are exposed
as a consequence of their employment, provided these
persons are fully aware of and exercise control over
their exposure.
NOTE: DO not allow the device to directly contact the
skin due to warm operating temperatures.
manual conventions
Quick Start ....................................................................................................................4-5
Accessories ........................................................................................................................ 5
Introduction ........................................................................................................................ 6
Operation ........................................................................................................................ 7
Using your Palladium II Transmitter ................................................................ 7
Changing your Transmitter Configuration .................................................... 7
Heat Sink ....................................................................................................................8-9
Components .............................................................................................................. 10-11
Programming .............................................................................................................. 12-19
System PC Controller Application Software
...........................................................12
Transmitter Control Application
...................................................................................13
Specifications .............................................................................................................. 20-21
Warranty ......................................................................................................................22
Contact Us ......................................................................................................................23
TABLE OF CONTENTS