User's Manual

4
1 Connect the transmitter antenna to the SMA connector on the bottom of the Palladium unit.
2 If you plan to use audio, connect one or two microphones to the Audio 1 and/or Audio 2
LEMO connectors. If using monaural, use Audio 1.
3 Connect power and video input via the Multi I/O cable to the 6-pin Hirose connector:
a Attach your camera video input (75 ohm composite video source in
PAL or NTSC) to the Multi I/O cable BNC connector.
b Apply the necessary power to your camera (use supplied cable or
external source) and turn ON.
c Attach a 12 VDC power source (such as the supplied battery pack or
the AC power adapter) to the Multi I/O cable via the Molex connector.
The input voltage range is from 10 to 16 VDC.
WARNING: Do not apply power to the transmitter unless an antenna or non-radiating
load is connected to the Antenna SMA connector.
Complete these steps:
1
2
3
Palladium Transmitter, Top View
QUICK START
Typical Wiring Configuration
A2
L
A1
R/M
TELEMETRY
Palladium II
VIDEO TX
TELEMETRY
CHANNEL
Palladium II
VIDEO TX
Typical Palladium II Configuration
Antenna
Audio
Camera
Battery Pack
Power Option
PALLADIUM II