User's Manual

PROGRAMMING

Chaining Input

Chaining input activates the chaining data port. This is not normally used except in

repeaters and high speed data transmission products.

Chain Number

Chain no. (not normally used) assigns a chaining tag number to the stream associated

with the transmitter’s video encoder. This can be user-defined to 0, 1, 2, 3, 4, 5, 6, 7, 8,

or 9. Normally 0.

Chaining Output

Chaining output (not normally used) assigns the output of the video encoder to the

chaining port. Normally OFF.

Current Configuration

Current config indicates the preset that is currently being programmed or viewed, this should

be the same as the preset selected by the channel switch.

Scrambling

Scrambling selects 3 different scrambling options: OFF (no scrambling), AES128, AES256 (op-

tional), or ABS (a proprietary 32 bit scrambling algorithym).

Heartbeat Enable

Heartbeat enable activates a beating heart on the screen video graphic to indicate that a link is

still functioning even if there is no motion on screen.

NOTE: Chaining is digital signal input

and output through the 16-pin Data,

Chaining, and Control Connector.