User's Manual

17
PROGRAMMING
Video Sharpness
Video sharpness is a filter that may be switched in to smooth out blockiness in the
video.
Audio Encoder
Audio encoder selects quantity of active audio channels (2 maximum), sampling rate
(8, 16 or 32 KHz) which determines upper frequency response, and sampling bits (8 or
12) which determines audio signal to noise. Options are: Off, 8 KHz 8 bit stereo, 16 KHz
8 bit mono, 16 KHz 8 bit stereo, 32 KHz 8 bit mono, 32 KHz 8 bit stereo, 32 KHz 12 bit
mono, 32 KHz 12 bit stereo.
Audio Input Level
Audio input level selects the audio preamp gain level, options are:
0 dB, 12 dB, 24 dB, 36 dB, 48 dB. Use 24 dB for DTC supplied microphones. Note: 3.5
VDC phantom power is at the microphone input for powering electret condenser
microphones.
Unit Name
Unit name allows the user to enter a name (up to 8 characters) for the transmitter that will be
stored in memory.
Sleep Mode
Sleep mode shuts down most functions in the transmitter except the control functions. This
can be used to conserve battery power and yet allow the transmitter to become active again
with a simple command.
Data
Data allows activation of the RS232 half duplex serial data channel and to select parity mode.
Data Baud Rate
Data baud rate selects data channel baud rate, standard rates between 1200 and 115,200 baud
are available.