User's Manual

11
COMPONENTS and PROGRAMMING
Transmitter Antenna Connector (SMA) This connector attaches to the
transmitter antenna and carries the RF output signal. Always ensure
the transmitter antenna is attached before operating the Palladium
Transmitter.
Muiti I/O Connector (6-pin Hirose) This connector provides
connections for the DC Power Input, DC Camera Power,
Programming, and 75 Ohm Composite Video Signal.
1 Ground
Video In 75 Ohm 6
RS232 In 5
RS232 Out 4
2 +V Power
10V - 16V
3 Camera Power Out 10V -16V
Programming
Frequency and channel configurations are programmed into the transmitter by the factory at
the time of order.
NOTE: FCC 90.203 (e) prohibits anyone other than the manufacturer, qualified service
or maintenance personnel from altering the frequency programming of the transmitter.
Please contact the factory for additional information regarding programming
frequencies.