User's Manual

DTC COMMUNICATIONS, INC.
9
ANTENNA
PROGRAMMING
CABLE
CHANNEL/
MODE SWITCH
INIT PUSH-BUTTON
TEST PUSH-BUTTON
BREAKWIRE
STANDBY
WIRE
LED
POWER
QUICK START
1 Connect an antenna to the RF Output connector on the transmitter.
2 Connect the break wire and or standby wire depending on the desired configuration.
3 Using the supplied screwdriver, turn the channel selector to the correct channel number.
4 Connect the power source to the PB-5’s power terminals.
5 If standby wire is used the PB-5 will not be enabled until the wire is removed. You will have to remove the wire to
activate.
6 If standby wire is not used, the PB-5 is activated immediately, and will operate within the programmed parameters.
7 If the default settings are not the desired settings, then programming is required. Go to the programming section on
page 12 to program the PB-5 with new settings.
2
5
1
3
4
Warning: Do not apply power to the transmitter
until an antenna has been connected in step 1.
Warning: Do not exceed 7.5 Volts