User's Manual

DTC COMMUNICATIONS, INC.
14
PROGRAMMING
1 Connect the antenna to the PB-5.
2 Install the programming cable into the RS232
connector on the PB-5.
3 Plug the serial cable of the programming cable
into the COM1 or COM2 port of your computer.
4 Select Start, programs, DTC communications on
your computer.
5 The system allows you to select device COM1 or
COM2, depending on which serial port you are
connected to.
The cycle power screen displays.
6 Connect the battery pack to the PB-5 and click
OK.
A message screen displays PB-5 downloading.
7 Click on the TX Tab of the screen.
8 Click on the channel you need to change and click
on the Edit Channel button.
9 Enter the new settings in the “Enter new
Frequency screen. You can also make
changes to the width, motion detect, and
the mode.
10 Click on the OK button.
Serial Port of
computer: COM1
or COM2
Antenna
POWER