Operating Instructions

The alarm is the same for both beacon transmitter mode and alarm transmitter mode. It is
a 50% duty cycle, 1 kHz tone transmitted once per second.
Antenna
The antenna connector on the PB-3 is an MMCX. Various wire antennas can be used
with the PB-3; it has an SWR tolerance of 12:1 (or better) . The wire antenna shipped
with the unit is optimized for the frequency of operation. Ideally, it will be kept stretched
out and away from metal objects as much as possible. Contact the factory for other
antenna configurations.
Operation
1. Choose beacon transmitter or alarm transmitter mode. Connect the MODE and
GROUND pins for alarm transmitter mode, leave it open for beacon transmitter
mode.
2. If motion sensing is desired, connect a wire between MOTION ENABLE and
GROUND.
3. If a breakwire input is desired, connect it between the BREAKWIRE and GROUND
pins.
4. Connect a suitable antenna.
5. Connect a 6-volt power source.
6. Verify that the signal is being received.