User Manual Part 2

DTC COMMUNICATIONS, INC.
12
WALL MOUNTING SCHEME
Wall-Mounting the MiniBox-4
To wall-mount the MiniBox-4, complete the following steps:
1. Dry-fit the MiniBox on the wall and make a pencil mark on the wall at
the top-center mounting slot.
2. Drill a pilot hole at the pencil mark for a mounting screw. Make sure
the wall is composed of solid, strong material such as wood or metal,
Select a fastener that will support at least 30 pounds.
3. Install the screw but leave enough of the shank exposed (1-1/4”
minimum) to hang the MiniBox-4 on.
4. Hang the MiniBox-4 as shown (left).
5. With the MiniBox-4 plumb and level, drill and mount a second screw
in the bottom mounting hole.
6. Tighten the top screw.
Top of MiniBox-4
WARNING: To prevent
overheating, make sure the rear
vent is not blocked.
WARNING: Never stand on or
place weight on the MiniBox-4.
A
N LOG
W
D GIT
AL
D
NOTE: Do NOT overtighten the mounting screws. Tighten enough to snug
the wall mount bracket to the wall. Overtightening may bend or damage the
mounting plate.