User Manual Part 1

DTC COMMUNICATIONS, INC.
9
MAIN COMPONENTS
Control
DTMF tones can be used to pan and tilt the camera
(transmitter units only), and to actuate many camera
functions. DTC’s low current R99WS control receiver
has been integrated into the transmitter models for use
with a two-way radio, included with the system.
VPN and WiFi units are controlled via an internet web
browser user interface. The browser-based controls are
described in this manual.
Video
Analog video transmission is accomplished by DTC’s
2 Watt/5 Watt VMX series video transmitter. These
transmitters feature ten user programmable channels,
an efficient switching power supply, and low heat
generation.
Digital video transmission is accomplished by DTC’s
Palladium video transmitter with an output power of
1 Watt. These transmitters feature COFDM and digital
encryption for secure signals in non-line-of-sight
environments.
IP video is viewed as either JPEG video or MPEG-4,
depending on user selection.
Power
The MiniBox-4 operates on 110 VAC power. A power
cord and a wiring block (for hard-wiring) has been
provided.
Power Considerations
The MiniBox-4 can be powered by
any standard 110 VAC, 15 amp
branch circuit.
The AC Power Reset provides
overcurrent protection for the
Minibox-4 system.
The AC Breaker Reset provides
overcurrent protection for all
accessories plugged-into the
outlets provided inside the
MiniBox-4.
Five amps is the total current
allowed for all accessories
plugged-into the four outlets.
W
A
N LOG
W
A
NALO
D
BEFORE PLUGGING IN OR CONNECTING
POWER TO THE SYSTEM, BE SURE THE
PUSH BUTTON ON/OFF SWITCH IS IN THE
OFF (OUT) POSITION. HARD WIRING MUST
BE INSTALLED BY A LICENSED ELECTRICAL
CONTRACTOR, IN ACCORDANCE WITH
NATIONAL AND LOCAL ELECTRICAL CODES.