User Manual Part 1

DTC COMMUNICATIONS, INC.
5
A
W
D
7. If your MiniBox-4 will be using an analog video
transmitter, select the transmitter power output setting
with the HI/LOW PWR switch. The power switch will
select either 5 Watts or 2 Watts.
8. If your MiniBox-4 will be using an analog video
transmitter, select the (optional) encryption setting
for your transmitter output with the ON/OFF SCR
(scrambled) switch.
9. BEFORE PLUGGING IN OR CONNECTING POWER
TO THE SYSTEM, BE SURE THE PUSH BUTTON ON/
OFF SWITCH IS IN THE OFF (OUT) POSITION. Using
the pre-wired 10-foot power cord provided, plug in
to a suitable 110 VAC power source. HARD WIRING
MUST BE INSTALLED BY A LICENSED ELECTRICAL
CONTRACTOR, IN ACCORDANCE WITH NATIONAL AND
LOCAL ELECTRICAL CODES. Connect incoming 110 VAC
cable to the white connection strip located in the bottom
of the utility box, respecting the color-coded wires (see
table). Once the power is properly connected, push the
Power button ON. (This is a push ON/push OFF switch.)
The red LED glows. The camera executes a robotic self-
test.
10. If your MiniBox-4 will be using a DTMF control radio,
test the DTMF commands. Monitor the movements, video
signal, and image quality with a setup monitor and DTMF
controller. Refer to DTMF Control section.
11. If your MiniBox-4 will be using cellular or router IP or
WiFi, test the web browser-based control. Refer to the
WiFi or corresponding optional router or modem section.
QUICK START
Color Wire
Green Ground
White Neutral
Black Line
AC Power
Shipping Case-Custom Foam
NOTE: Make sure power cables do not block camera view.
TOP
Pwr Cable
Accessory Storage
DTMF
Radio
CAUTION: LIVE VOLTAGE AT WIRING
BLOCK. HARD WIRING MUST BE
INSTALLED BY A LICENSED ELECTRICAL
CONTRACTOR, IN ACCORDANCE WITH
NATIONAL AND LOCAL ELECTRICAL
CODES.