User Manual Part 1

DTC COMMUNICATIONS, INC.

Complete the following steps:

1. Unpack the components from the shipping container.

2. Mount the utility box in a temporary (service bench) location using

one of the methods described in the Installation section.

3. Disengage the support bracket (see warning).

4. If your MiniBox-4 will be using a digital or analog video transmitter

connect both transmitting antennas to maximize the coverage

pattern or use one antenna to maximize gain in one direction only.

To use both antennas, connect the splitter; to use one antenna, use

the double-female adapter. (Factory-set to both antennas.)

5. If your MiniBox-4 will be using a digital or analog video transmitter,

set the channel selector in the VIDEO TX section of the control

panel to the desired frequency for your Video Transmitter.

6. If your MiniBox-4 will be using a DTMF control radio, set the

channel selector in the DTMF RX section of the control panel to the

same frequency as being used by your radio. The MiniBox-4 lists

both DTMF and Transmitter pre-programmed frequencies on the

Quick Start Card located on the inside of the door.

QUICK START

WARNING

Avoid permanent damage to the

camera!

• Disengage the support bracket

(down position) before turning the

system ON.

• Engage the support bracket

(up position) before moving or

shipping the system.

To Disengage the support

bracket: pull spring tabs out and

move bracket down one position.

To Engage the support bracket:

pull spring tabs out and move

bracket up to highest position.

Engage

Disengage

Support Bracket

NOTE: The MiniBox-4 offers three viewing windows; front and two sides. You

may choose to use one or all three. The unit is shipped with a Velcro® curtain

covering the front window and inserts that block the side windows. Remove

the curtain and/or inserts from the window(s) you plan to use. Always keep

unused windows blocked when not in use to prevent light from entering the

enclosure.

WARNING: Drop and shock sensitive equipment. Avoid permanent damage

to your system. Do not ship this product without proper packaging. This unit

must be boxed and protected with packaging materials before shipping.