User's Manual

DTC COMMUNICATIONS, INC.

COMPONENTS

ALARM LED This red LED indicates a valid video signal

is not present. In addition, if no other LED is ON, the

ALARM LED indicates battery is less than 10 Volts.

RF LED This green LED indicates that the RF

output is ON.

RF Button This membrane switch toggles ON/OFF the

RF output. Normally this should be left ON.

CONFIG Button This membrane switch cycles through

the eight channels.

Channel LEDs These green LEDs, numbered 1 through

8, indicate the channel number currently selected.

Each channel represents a set of preconfigured

settings.

Do not cinch the Velcro

battery strap here or you

could damage the PC board inside.

Cinch the battery strap here.

Power Connector

Hirose Connector

Battery Pack

You must disconnect the Hirose Connector and the

Power Connector in order to access the Battery Pack.

HVT, Partially Disassembled View

HVT Transmitter Control Panel,

Located on Bottom