User's Manual

Using the Receiver
DSS-900-KT Digital Spread Spectrum Surveillance System 7
VOLUME sets the volume of the front panel speaker or of the headset if
plugged in. Remember, if a headset is plugged into either jack in the
AUDIO section of the front panel, the speaker is automatically disabled.
You may use both headset jacks.
CAUTION Be sure that the receiver is set to the channel number
matching the frequency of the TX.
2.Receiver
The RECEIVER section on the front panel
contains two LEDs and two controls.
RX ON LED tells you that power is applied
to the RX and that the tape recorder
power is enabled. It does not mean that
the RX is necessarily receiving a signal
from the TX,
TX LOCK LED tells you that the RX is
receiving a signal from the TX and that
the signal is of sufficient strength to be
locked on.
CHANNEL SELECT enables you to switch
the RX to the frequency printed on the TX
in use. Use the label on the inside of the
top cover of the case to convert TX
frequency to CHANNEL SELECT number.
If the RX is on and set to the correct
channel, and if the TX is on and supplying
a strong signal, the TX LOCK LED will be
lighted. Unless otherwise requested at
the time of purchase, the TXstandard
factory setting is Channel 2.