User's Manual

16
PROGRAMMING THE COLLAR
When adding an “Add-On” collar, the collar will need to
be programmed to the transmitter. If your current collar
unit is not responding to the transmitter, it may also
need to be reprogrammed to the transmitter.
1. Select the desired Collar Selecting Switch position
on the transmitter.
2. Hold the Transmitter Magnet Indicator (white dot)
directly against the Magnetic Activation Switch (small
bump) on the right side of the Collar Receiver.
3. The SmartLED light inside the Collar Receiver will
light up solid for about 1 second, followed by 6
flashes. You must keep the Transmitter next to the
Collar Receiver during this time.
4. Continue to hold the Transmitter against the Collar
Receiver until the SmartLED light stays on solid. The
Collar Receiver is now in the Code Running Mode (the
SmartLED light will stay lit for approximately 8
seconds while it is in this mode).
5. Remove the Transmitter from the Collar Receiver
and press the NICK and CONT buttons
simultaneously while it is in the Code Running Mode.
6. When the SmartLED blinks 3 times, the Collar ID
is programmed and the Collar Receiver is now ON.
NOTE – Do not move the Transmitter Magnet Indicator
from the Collar Receiver Magnetic Activation Switch
until after the SmartLED stops flashing and stays on
solid or the Collar Receiver will not go into the Code
Running Mode. You must press the NICK and CONT
buttons simultaneously while the SmartLED is lit solid.
9
Collar Receiver
PARTS & FUNCTIONS
Contacts - Contacts should fit snugly against the
dog’s neck to ensure good contact with the skin. For
more information on the proper fit of the collar, see
page 17.
*R.A.P.T. 1450 will also
have Beeper Horn and
Beeper Wire.
Charging Receptacle
SmartLED
Indicator Light
Magnetic ON/OFF
Activation Switch
Contacts
Collar Belt with
MAXX-Range™
Antenna
Collar SmartLED Indicator Light - Shows charging
status and battery life status (see page 11).
Magnetic ON/OFF Activation Switch - Turns the
Collar Receiver unit ON and OFF (see page 13).
Buckle
Beeper Horn (R.A.P.T. 1450 only) - The Beeper Horn
is attached to the collar belt. It will emit a loud tone
audible from up to 450 yards away.
Beeper Wire (R.A.P.T. 1450 only) - The Beeper Wire
provides power and communication from the Collar
Receiver Unit to the Beeper Horn.