User's Manual

ManualsBrandsDT Systems ManualsElectronicsremote control for a canine training collar

Transmitter

PARTS & FUNCTIONS

Button #2*

(Function varies

according to model)

SureGrip

Strap

Battery Cover

Rapid Access Button

(default Nick Stim.)

LED Indicator Light

Continuous

Stimulation Button

Collar Selector Dial

with Lockout

Button #1*

(Function varies

according to model)

R.A.P.T. 1400 & CoverUp

Button #1 - Vibration

Button #2 - Jump

R.A.P.T. 1450

Button #1 - Locate

Button #2 - Run/Point mode (Run

& Point, Point Only)

R.A.P.T. 1400 ELITE

Button #1 - Launch

Button #2 - Locate

Antenna

Transmitter Antenna - Always check that the

Antenna is securely fastened to the transmitter before

each use. Hand tighten only. Use caution when

attaching Antenna as over-tightening may cause

damage to the Antenna or antenna mount.

Intensity Level Dial

Lanyard Connection

Magnet Indicator

(white dot)

SETTING THE INTENSITY LEVEL

Setting the Jump Stimulation Level (cont.):

1. Press and hold Button #2 (Jump button).

2. While holding the Jump button, turn the Intensity

Dial to the desired Jump stimulation level. The

LED will start flashing to indicate that you are pro-

gramming the Jump stimulation level

3. Release the Jump button. The LED will flash the

number of the new Jump level to confirm success-

ful Jump level programming.

The Jump intensity setting will stay at this level until a

different Jump level is programmed. Changing your

normal intensity level will not affect the Jump setting.

When applying the Jump stimulation, the intensity

level will return to its normal setting when the Jump

button is released.

SETTING THE RAPID ACCESS BUTTON

The Rapid Access Button’s default setting is Nick

Stimulation. However, you can set it to be Continuous

Stimulation, Vibration, or Locate (varies with model).

1. Set Collar Selector Dial in the Lockout position.

2. Turn Intensity Dial to 1 (Nick), 2 (Continuous), 3

(Vibration), or 4 (Locate).

3. Press and hold the Rapid Access Button and But-

ton #2 simultaneously until the LED turns on.

4. Release buttons. The LED will flash 1 to 4 times

depending on chosen setting as confirmation.