User's Manual

14
To Test the Vibration:
(R.A.P.T. 1400 and CoverUp only)
1. Press Button #1 on the transmitter (Vibrate button)
and the collar unit will vibrate only.
Before testing, make sure that both units are fully
charged and the power to the Collar Receiver is “ON”.
To Test the Electronic Stimulation:
1. Place the tester firmly on the contacts
of the Collar Receiver.
2. Set the intensity (note - an intensity
level setting of 4 or less might not be
enough to light the tester).
3. Push the ‘NICK’ or ‘CONT’ button.
4. The tester light will quickly flash once when the Nick
button is pushed and light repeatedly when the
Continuous Stimulation button is pushed (the test
light will be brighter at higher intensity levels).
TESTING
To Test the Jump:
(R.A.P.T. 1400 and CoverUp only)
1. Press Button #2 on the transmitter (Jump button)
and test light brightness will reflect the user-
programmed Jump level (see page 19).
2. The intensity level will return to its original setting
when the Jump button is released.
NOTE: If the collar unit is not responding to any signals
from the transmitter, the collar may need to be repro-
grammed to the transmitter (see page 16).
11
SmartLED
**Charging Error - If the SmartLED has a long blink every
other second while charging, the rechargeable battery pack
may need to be replaced. New batteries may also initially
give an error light. Contact D.T. Systems if the problem
persists after a few charging sessions.
R.A.P.T. Series units are equipped with the
SmartLED battery status system. The SmartLED
system lets you know when the unit is charging and
when the charging is complete. It also gives you a
status on how much charge is remaining in the battery
during use, when it needs charging, and when the
batteries will need to be replaced.
Action
LED COLOR/
PATTERN
Status
Charging
Red Charging
Green Charging complete*
Long Red blink
every other second
Charging error**
Flashing Green 51%-100% charge left
Flashing Red 21%-50% charge left
Red double flash
or rapid flash
Battery charge is low and
requires charging soon
While Unit
is On
*Charging Complete - Once charging is complete, your
unit will go into a trickle charge to prevent overcharging.
However, it is recommended that you remove your unit from
the charger as soon as charging is complete.