Operating Instructions and Installation Instructions

Section 2 – Using an Extension
5
Access Code Dialled Service Feature Description
* 21 ext. # Set All Call Diversion From Own Extension
* 2 N ext. # Set Divert No Answer After delay N = 2 – 9 for 5, 10, … 45 sec.
# 21 ext. # Cancel All Call Diversion from another extension
# 21 # Cancel All Call Diversion from own extension
# 20 # Cancel all diversions
*31 ext. # Set Diversion On Busy
#30 # Cancel Diversion On Busy
#30 ext. #' Cancel Diversion On Busy from another extension
*7411# Toggle Do not disturb
*1 Read message on Executive Terminal (optional)
*6 … Extension feature programming code
*7 … Extension feature programming code
*8 … System feature programming code
*9 … System feature programming code
Feature Access Codes after Recall (R) or Transfer key
Access Code Dialled Service Feature Description
R0
(or 9)
Outgoing Exchange Line Call
(* For systems using 9 for a line)
R ext. Enquiry call to an extension (hang up to transfer)
R19 Open relay contact of connected door phone
R** account_PIN Code to enter before dialling out if account codes are active
R* ext. Make a brokerage call to an extension
R*0
(or R*9)
Make a brokerage call to exchange line
(* For systems using 9 for a line)
R*9 exch. line
(or R*0 exch. line)
Make brokerage call to specific exchange line
(* For systems using 9 for a line)
R3 ext. Initiate conference call with extension
R39
(or R30)
Initiate conference call with free exchange line
(* For systems using 9 for a line)
R30 exch. line
(or R39 exch. line)
Initiate conference call with specific exchange line
(* For systems using 9 for a line)
R500 Redial last number
R501 – 599 Dial system speed numbers
R70 – 79 Dial extension speed numbers
R80 Make a general call to all extensions
R81 Extension group 1 call with 1 ring
R82 Extension group 2 call with 2 rings
R83 Extension group 3 call with 3 rings
R85 Park an exchange line
R86 Pick up any call
R87 Send a flash signal to exchange line
R88 Make outgoing call with data protection
R90
(or R00)
Hold an exchange line call
(* For systems using 9 for a line)
R9 exch. line
(or R0 exch. line)
Pick up call on exchange line 1 – 6
(* For systems using 9 for a line)