Operating Instructions and Installation Instructions

Section 3 – System Programming
49
Disarm the Alarm Loops
System Settings  Alarms  Disarm alarm 1 /
2
Clear Alarm settings
Alarm Master Reset (erases all settings)
System Settings  Alarms  Reset alarms
Clear all Alarm 1 Settings (erases all settings)
Clear all Alarm 2 Settings (erases all settings)
System PIN Number
The system PIN number is a security block to stop unauthorised access to system programming. It
can be changed to any four-digit number. The power LED will stop blinking and remain on
permanently when a new PIN has been set.
Default
The default PIN is 7373.
Change PIN number (4 digits)
General Settings  Change pin code
System Size
The system must be told when an analogue expansion card has been fitted, ISDN cards are
automatically detected. When an expansion card is fitted it should occupy slot 1 first, then slot 2. The
expansion cards fitted should then be programmed accordingly. Any of the configurations shown in
the table on page 3 are valid.
Default
The system will be delivered factory-configured to the correct size. Use this code if cards are
removed or installed.
No expansion cards fitted.
System Settings  System size  2+8 system
One expansion card fitted.
System Settings  System size  4+10 system
Two expansion cards fitted.
System Settings  System size  6+12 system
System Speed Dialling
The system provides up to 99 speed dial entries of up to 25 digits. The system speed dial number are
exempt from call barring class of service 1, 2 and 3 from account code enabled extensions, unlike
individual extension speed dial numbers (see page 14) which undergo full class of service checking.
Default
All 99 system speed dial entries are empty.
Program system speed dial number
System Settings  System speed numbers  Speed number xxx
Clear all system speed dialling numbers
Clear system speed dial number
PIN alarm_no alarm_no
PIN
PIN
PIN
old_PIN, new_PIN new_PIN
PIN
PIN
PIN
PIN entry tel_no
Key
entry =
501 to 599 for speed dial
tel_no =
Telephone number to
program, up to 25 digits
PIN
PIN entry