Operating Instructions and Installation Instructions

Installation & Programming Manual
44
CLIP data and CLIR status are sent to the ISDN network when an outgoing call is made. COLP
data and COLR status are sent to the network when a call is answered.
When an extension sets up or answers an external call the CLIP/COLP data is based on the MSN
number programmed for the extension. If there is no MSN number programmed then the base
number for that particular ISDN line is used. If there is no base number programmed then no
CLIP/CLIR data is sent, though the network may add it’s own later. In the case of external call
diversion and external alarm calls the ISDN base number for the line is used.
 Note: After installing or changing the lines from point to point to point to multipoint the
system should be powered off after a delay of six minutes and then powered up while
connected to the S bus to correctly establish ISDN settings.
Default
Default is point to multipoint operation for both ISDN lines. All MSN and MSN ignore tables are
empty. Incoming calls to an MSN number will ring only one extension, as contained in the code.
CLIP is active – your number is sent to other callers and COLR is inactive, your number is not
withheld from callers when you answer.
Set both ISDN lines as point to point mode
ISDN Settings  Set pt to pt/mpt  pt
Set both ISDN lines as point to multipoint mode
ISDN Settings  Set pt to pt/mpt  mpt
Program ISDN base number for ISDN card 1
ISDN Settings  Set MSN numbers  Base number 1
Clear ISDN base number for ISDN card 1
Program ISDN base number for ISDN card 2
ISDN Settings  Set MSN numbers  Base number 2
Clear ISDN base number for ISDN card 2
Enable CLIR system wide
ISDN settings  CLIR  On
Disable CLIR system wide
ISDN settings  CLIR  Off
Enable COLR system wide
ISDN settings  COLR  On
Disable COLR system wide
ISDN settings  COLR  Off
Program MSN number to extension
ISDN Settings  Set MSN numbers  MSN number ext.
Clear MSN number from extension
Reset all MSN numbers
ISDN Settings  Clear all MSN numbers
Program MSN numbers to ignore
ISDN Settings  Set MSN ignore no.
Clear all MSN numbers to ignore
ISDN Settings  Clear all MSN ignore no.
Clear an individual MSN number to ignore
Enable access to analogue line 1
ISDN Settings  Line 1 Off/On  On
Disable access to analogue line 1
ISDN Settings  Line 1 Off/On  Off
Select ISDN lines first on outgoing calls, then analogue
ISDN Settings  Pick analog/ISDN first  ISDN
Select analogue lines first on outgoing calls, then ISDN
ISDN Settings  Pick analog/ISDN first  analog
PIN basenumber
Key
basenumber =
ISDN card base number
(max 12 digits)
PIN
PIN basenumber
PIN
PIN ext. number
Key
msn_number =
MSN number (12 digits
max)
ignore_number =
MSN number to ignore (8
digits max)
ignore_entry =
1-8 for MSN ignore table
entry
PIN ext.
PIN
PIN ignore_entry ignorenumber
PIN
PIN ignore_entry