Operating Instructions and Installation Instructions
Section 3 – System Programming
39
Switch on automatic day/night switching
General Settings Clock Settings Automatic mode
Manual Day/Night Setting by programming code
Set to Day Mode and switch off automatic day/night switching
General Settings Day-Night mode Adhoc day mode
Set to Night Mode and switch off automatic day/night switching
General Settings Day-Night mode Adhoc night mode
Manual Day/Night Setting with switch
Use switch on alarm loop 2 for day/night switching
System Settings Alarms Alarm 2 function day/nightswitch
When the switch contacts are closed the system will be in night mode, when the contacts are opened
the system will switch to day mode. This setting will override any security alarm function previously
programmed onto alarm loop 2.
DTMF Extensions
DTMF extensions will allow only DTMF signalling. The time window for recall pulses is
programmable for DTMF extensions to prevent problems with hook switch bounce.
For all extensions programmed as DTMF only a recall signal is recognised if the pulse length falls
between a certain programmable period.
Default
Extensions are compatible with both pulse and DTMF signalling. The time window for DTMF only
extensions is between 40 and 160 ms.
Set an extension as DTMF only
System Settings miscellaneous Enable DTMF phone
Reset an extension from DTMF only
System Settings miscellaneous Disable DTMF phone
Set default recall time window (40 – 160 ms)
Set programmable time window
Exchange Line Assignment
This separates the Exchange Line ports into groups for individual extension access. When there are
two or more exchange lines, extensions can be programmed to make outgoing calls on designated
lines, e.g. a fax line. The default is that all extensions can access all exchange lines. The system will
always access the first free line from 1 to 6, in that order.
Default
All extensions are able to make and receive calls on all exchange lines.
Step 1: Set which lines can be accessed by extensions.
Allow an extension to use an exchange line
System Settings Bundle Splitting Assign Exch x to Ext
Prevent an extension using an exchange line
System Settings Bundle Splitting Cancel Exch x to Ext
Step 2: Enable the exchange line group feature
Enable the Exchange Line Group Feature
General Settings Exch allocation On
Disable Exchange Line Group Feature
General Settings Exch allocation Off
PIN
PIN ext
PIN ext
Key
window =
0 default 40 – 160ms
1 between 60 – 160ms
2 between 70 – 160ms
3 between 80 – 160ms
4 between 90 – 160ms
5 between 100 – 160ms
window
PIN line ext
Key
line =
0 for all exchange lines
1 - 6 for single exch. line
PIN line ext