Operating Instructions and Installation Instructions

Installation & Programming Manual
32
Switch on incoming call control for exchange line
General Settings  Auto answer settings  Set call control
Switch off remote paging for all exchange lines
General Settings  Auto answer settings  Disable Remote Paging
Switch on remote paging for exchange line
General Settings  Auto answer settings  Set Remote Paging
Switch off DISA for all exchange lines
General Settings  Auto answer settings  Disable DISA
Switch on DISA for exchange line
General Settings  Auto answer settings  Set DISA
Program DISA emergency call forward number (also diversion number)
System Settings  Exch divert number
Switch off remote programming for all exchange lines
General Settings  Auto answer settings  Disable remote control
Switch on remote programming for exchange line
General Settings  Auto answer settings  Set remote control
Step 3: (Optional) Secure auto-answer features with access codes
Program DISA / call control access code
System Settings  Auto answer access codes  DISA code
Program Remote programming access code
System Settings  Auto answer access codes  Remote control
code
Program Remote paging access code
System Settings  Auto answer access codes  Remote paging
code
Step 4: (Optional) If you wish the call to ring as a normal call first, and auto-answer only if
unanswered, program the delay for each line here. By default the call will not ring internally
and be auto-answered within 5 seconds of ringing.
Program delay before answering call
 Note: this code also enables the Courtesy service option, but the
courtesy service is overridden by the auto-answer modes of step 2. If auto-answer is
disabled on exchanges lines after entering this code then the courtesy service must also be
disabled.
Step 5: Switch on the auto-answer service
Switch on automatic answering
General Settings  Auto answer settings  Auto answer Off/On  On
Switch off automatic answering
General Settings  Auto answer settings  Auto answer Off/On  Off
Boss-secretary Mode
A boss-secretary mode can be enabled which allows a boss terminal on extension 13 to call a
secretary terminal on extension 15 with a distinctive tone in place of the normal ringing cadence, this
tone will sound even if the extension is busy on a call. In addition, the executive terminal will show
the caller on-screen, e.g. ‘Sec call’ or ‘Boss call’.
Default
Boss-secretary feature is inactive
Enable boss-secretary operation
General Settings  Boss / Secretary  Enable boss-secretary
Disable boss-secretary operation
General Settings  Boss / Secretary  Disable boss-secretary
line, ans_type
Key
line =
0 for all exchange lines
1 - 6 for single exch. line
ans_type =
1 for answer with tone
2 for answer with msg. 1
3 for answer with msg. 2
5 for msg1 during day,
msg2 during night
number =
emergency call forward
number (25 digits max)
line, ans_type
line, ans_type
PIN number
line, ans_type
PIN access_code
PIN access_code
Key
access_code =
security number, 4 digits
long
line =
0 for all exchange lines
1 - 6 for single exch. line
delay =
1 – 8 for delay before
answering call 1=5 secs
… 8=40secs
PIN access_code
line, delay