User`s manual

Phone: [phone] Fax: [phone]
Service: [phone]
Web Page: www.DSPManufacturing.com
Email: [e-mail]
14
Verify that the input voltage as stated on the DE1 nameplate, matches the
customer-supplied voltage. If the voltage does not match, STOP installation of the
DE1 and contact Customer Service at DSPM.
2. Verify that Input cable and conduit are routed correctly and are in position to
connect the unit.
3. Open the Unit and verify the optimum location for Conduit Access.
4. Punch the appropriate sized conduit hole in the chosen location.
5. Pass wires through the mounting hole.
6. Secure conduit fitting to the panel of unit.
7. Connect power wires to the input, neutral and ground terminal blocks. These are
pre-wired to the DE1 System. See picture below.
(Pre-Wired Input /Output terminals block(s)