Owner`s manual

ANTI-MODE 2.0 DUALCORE
OWNER'S MANUAL
4.7 Audio Settings
Audio settings can be configured from this menu.
Use the manual channel balance adjustment to match the levels of the left and right
speakers. Changes in this dialog take effect immediately. Press the OK button on the
remote to accept the new adjustment or press the BACK button to discard changes.
All internal processing is performed with 32- or 40-bit accuracy with the appropriate
number of bits reserved for headroom. However, if emphasizing (amplifying) filters are
used, some input signals could cause saturation / clipping at the output. The unit
automatically calculates the best headroom setting from the gains of the active filters.
However, if you only use the analog input and do not use the full input range, you can
change the headroom setting to a lower value. If the automatically calculated value is
too small (causing clipping at output), you can manually increase the headroom value.
The headroom value is automatically re-calculated every time you calibrate or change
filter settings, so remember to re-do your own adjustment as a last step in these
cases.
Compensation setting affects the overall bass level throughout the frequency range
Anti-Mode calibration was performed on. This setting can also lift (compensate) dips
residing in the area. Adjustment operates in real-time, so it is possible to look for a
subjectively good value while listening to audio (via Analog or Toslink input). Also the
BYPASS button on the remote is available in this screen.
Notice: channel balance, headroom, and dip compensation values are associated with
the current sound profile.
4.8 Input Settings
Input settings can be configured from this menu.
Rev. 1.1 2014-03-07 Page 20 (32)
CHANNEL BALANCE
Close
L R
00.0 dB
Ch. Balance
AUDIO SETTINGS
Headroom
Compensation
DIGITAL HEADROOM
Close
Min Max
00.0 dB