Owner`s manual

ANTI-MODE 2.0 DUALCORE
OWNER'S MANUAL
EXAMPLE: Boosting the lower bass under 50Hz by about 3 dB
How to do it step-by-step:
➢ Open main menu by pressing the MENU button on the remote
controller.
➢ Navigate to the Settings menu using the arrow buttons and press OK
to select it.
➢ Select the House Curve Tool using arrow buttons again (the first item
on the upper row.)
➢ Press OK and the House Curve tool opens. Using the LEFT and RIGHT
arrow buttons, set Tilt to 2 or 3. The approximated response is shown
on the screen.
➢ Using UP and DOWN arrow buttons, set Lift to 3.
➢ Once ready press OK to apply the new house curve
4.2 Tilt Curve Tool
The Tilt curve tool provides a method of changing the overall frequency response
slope of the treble. The motivation behind a tilt curve is (along personal preference) to
compensate differences in various recordings. One can, for example, make a profile
with treble tilted down to tame too “bright“ recordings.
Note: the QuickTone Treble, Tilt, and Loudness controls use the tilt curve filter,
overriding user settings.
The parameters of the tilt curve are:
✔ Freq: The transition frequency of the effect
(illustrated on the screen). Adjust using
LEFT/RIGHT arrow buttons or the blue-coded
button.
✔ Gain: Attenuation (negative values) or emphasis
(positive values) of the selected band. Adjust using
UP/DOWN arrow buttons or the orange-coded
button.
✔ Enabled: Enables or disables the applied tilt curve.
Please note that modifying the parameter values will automatically enable this
effect. Press the green button (followed by OK) to disable it again.
Rev. 1.1 2014-03-07 Page 14 (32)
20 50 100 5k
TILT CURVE
F 1500 GAIN-3
ENABLED
200 500
1k 2k
10k