Owner`s manual

ANTI-MODE 2.0 DUALCORE
OWNER'S MANUAL
PLEASE NOTE: After Anti-Mode gets rid of the room resonances,
one might find that the sound was generally improved but there's
not enough bass anymore. One possible reason is that the listener
has grown used to the exaggerated bass response previously
caused by room resonances.
If you feel the need to increase (or decrease) the overall bass
level, you can do this e.g. by utilizing the Bass Compensation
setting. Navigate into the settings menu, select Audio Settings and
Compensation. This adjustment affects the entire corrected
frequency range. It updates in real-time so you can listen to music
(via Analog or Toslink inputs) and choose a subjectively preferred
level of bass. There are also other means to shape the target
response (including QuickTone, House Curve and custom EQ filters)
that are described later in this manual.
After the calibration is done, you can view before and after measurements from the
Room Response (Measurement) menu. You can use the same menu to make and view
your own room response measurements.
3.Home Screen View
The default home screen view consists of three components. The currently active input
is displayed at the center.
Similarly, the currently active output is shown at the bottom of the screen.
The top of the home screen shows state information. The icons are (from left to right):
(1) Input sample rate (in kHz)
(2) Input bit depth (when available)
Rev. 1.1 2014-03-07 Page 10 (32)