User manual

EPower User Manual
Page 9 of 15
Copyrights DSP4YOU ltd
3.2.1.1 Rename device
By default, AVB endpoints will carry the name of the MAC Address of the network interface. The default name can
however be modified to a more meaningful “hostname”.
To change the name of the device, simply type a new name in the text window and click on the SET button.
The renaming is instantaneous and the device will appear in the tree with its new name.
3.2.1.2 Firmware upgrade
E-power firmware and Digital Signal processing embedded inside the device can easily be upgraded to new version
over the Ethernet. Click Browse to select the firmware you would like to upgrade the unit with.
Make sure not to un-plug the device during the firmware upload to prevent any corruption of the device.
3.2.2 Audio Video Bridging (AVB) stream configuration
The E-power AVB configuration requires limited setup. The following section will highlight steps involved in
building/deleting an AVB stream. Please refer to the
AVB primer for the basic terminology used through out this
section.
3.2.2.1 Build a Stream
Click on the “Configure AVB Stream” button to access the following dialog box.