User manual

EPower User Manual
Page 8 of 15
Copyrights DSP4YOU ltd
Following a successful installation, AVBStreamer tools will be automatically launched and discover modules on the
network. See the default startup screen below.
3 System Configuration
3.1 User interface overview of the AVB Streamer toolbox
E-power configuration software provides a simple user interface for configuration of the AVB and DSP setting of E-
power currently connected on the network. Note that AVB Streamer does not allow “offline” mode without being
connected to the network.
 A Device tree on the left side lists all discovered AVB devices on the network
 A center section tabbed based structure allows access to the various sections of the user interface
Tabbed Structure
 Device info: Provides overall view of the current settings of E-power device including the model number,
firmware version, IP settings.
 Audio settings: Digital Signal Processing section of the interface. Provides control to the basic gain control
and advanced DSP algorithms running on the on board Digital Signal Processor. Note that the digital signal
processing section will only be enabled if this feature was purchased.
3.2 E-power configuration
NOTE The following section will show print-screens from the AVB Streamer toolbox. Accessing the E-power directly
from Dana server will result in the exact same User interface. As mentioned earlier on, the AVB Streamer toolbox
software is only required in the absence of a Dana Server.
3.2.1 Device info page
AVB end points are automatically discovered and listed as part of the AVB tree. Once your PC connected to the
network, simply open the AVB Streamer toolbox to have access to all settings.
To access the settings of a specific device, click on the AVB device tree on the left. The device info page will
automatically load the settings for this device. See below an example.
AVB Device Tree
lists devices
discovered on
the network &
Virtual devices