User manual

EPower User Manual
Page 2 of 15
Copyrights DSP4YOU ltd
Description
Configurable as 2x20W in Bridge Tied Load (BTL) or 4x10W in Single Ended (SE) mode, E-Power fits the requirements of
both commercial A/V and I.T. installations. Hardware isn't the only innovative element of this product. From network
redundancy to our innovative auto-discovery protocol, E-Power provides un-paralleled level of abstraction to get
audio up and running. With our ZeroConf automatic configuration and hostname labeling of devices, setup of an E-
Line system is really only a drag & drop away.
Finally, aside from being a Plug&Play AVB-ready interface, E-power also answers the needs for small & low power
Digital Signal Processing (DSP). With our proven plug-in technology, DSP4YOU’s platform delivers flexibility without the
headaches of learning to program a new DSP platform. With the ability to upgrade plug-ins over the network, E-
power will evolve over time to better fit your client’s needs.
Hardware
o 400MHz quad-core processor
o Configurable as 2x20W or 4x10W
o 100Base-T Ethernet
o Redundant Ethernet connector
o Power-over-Ethernet (PoE)
Firmware
o ZeroConf setup
o Self discovery of device
o DHCP or Link Local addressing
o Plug&Play configuration
o Remote firmware upgrade over network
On-Board DSP
o 28/56bit fixed point DSP
o 48kHz sample rate
o Enabled based on the selected Plug-in (DSP configuration)
o Metering, Automatic Gain Control, Parametric equalizers, Compressor/Limiter, delay, phase, gain
System Diagram