User manual

AV2USB
Page 18 of 24
Copyrights DSP4YOU ltd
4.2.1.2 Static IP mode
The AVStreamer toolbox allow for setting up the device as DHCP/AutoIP (i.e. automatic addressing) or Static IP
addressing. Click on the SET button below to access the IP settings page.
By default, all units ship with DHCP/AutoIP mode and is the mode we recommend for all operation.
If using static, insure that you’re aware of what you’re doing else you may not be able to correctly configure the unit.
If you do set the unit in static mode and forget the IP address of the unit, you can easily retrieve it looking at the AVB
bridge window (little window application running in the background of the main application). Here is a scre enshot as
an example showing that 2 devices were discovered and their respective Mac address/IP.
4.2.1.3 Firmware upgrade
The AV2USB can easily be upgraded to new version over the Ethernet. Click Browse to select the firmware you would
like to upgrade the unit with.
Make sure not to un-plug the device during the firmware upload to prevent any corruption of the device.
4.2.2 Audio Video Bridging (AVB) stream configuration
The AV2USB AVB configuration requires limited setup. The following section will highlight steps involved in
building/deleting an AVB stream. Please refer to the AVB primer for the basic terminology used through out this
section.
4.2.2.1 Build a Stream
Click on the “Configure AVB Stream” button to access the following dialog box. The Talker List and Listener list on the
Left and Right pane of the dialog box are automatically generated based on the device discovered on the network.
They will most likely be different in your case. For the purpose of this demo, we’re using 1 x AV2USB and 1 x Eline unit.